One used Egan turret winder, 1991 new. Rewind diameter is 50” and has “on the fly cut off and transfer”, nonstop. Comes with a driven shear knife system with four male and female knifes. The rewind is set up for 3” ID cores. Foot print is 11’x9’x8’. 2 each 40HP DC motors to drive each of the rewind shafts. One AC gear motor to drive the turret and one 20HP motor to drive the shear knifes. The drives and controls are not with the winder. At the rear of the winder is a pneumatically loaded dancer roll for controlling the winder speed. One bowed roll after the slitters to help separate the slit webs.